Show interface errors
![show interface errors show interface errors](https://pgmodeler.io/uploads/images/thumbs/large/343edf974baa6a91e23ca8ca7142b3a2.png)
© Copyright 2008 EMC Corporation All Rights Reserved. Interface error Hi all, We have an interface which creates Contracts using IDOCs. If you stop seeing errors, move on with NIC teaming t-shooting. Run the backup client using one NIC (no teaming), clear the counters on both interfaces, and see what happens. NOTICE : Module 8, Ports 32 is module type Storage Services Module and model DS-X9032-SSM, status is ok *** Interface Information & Status *** Interface If the errors are immediately occuring on input at the interface connected to the client, that's likely where the problem lies. I will be using Debian 9 Stretch for the demonstration. I need a command that will show me loss of sync or maybe SFP errors.
SHOW INTERFACE ERRORS HOW TO
In this article, I will show you how to use ethtool command on Linux. Hello, I am looking to see if there is a CLI command for MDS 9124 running NX-OS that will dispaly all the ports and show me if there are any errors on them whether the are bad cables or such. can also be used to find a lot of information about connected Ethernet devices on your Linux computer. cluster1::> network interface show Logical Status Network Current Current Is Vserver Interface Admin/Oper Address/Mask Node Port Home - cluster1 clustermgmt up/up 192.0.2.1/192 node0 e0M true node0mgmt1 up/up 192.0.2.2/192 node0 e0M true node1mgmt1 up/up 192.0.2. It is used to configure Ethernet devices on Linux. The following example displays general information about all logical interfaces. NOTICE : Module 7, Ports 8 is module type IP Storage Services Module and model DS-X9308-SMIP, status is ok ethtool is a networking utility on Linux. NOTICE : Module 6, Ports 0 is module type Supervisor/Fabric-2 and model DS-X9530-SF2-K9, status is ha-standby This may not balance with the sum of the enumerated output errors, because some datagrams may have more than one error. NOTICE : Module 5, Ports 0 is module type Supervisor/Fabric-2 and model DS-X9530-SF2-K9, status is active * NOTICE : Module 4, Ports 12 is module type 1/2/4 Gbps FC Module and model DS-X9112, status is ok NOTICE : Module 3, Ports 12 is module type 1/2/4 Gbps FC Module and model DS-X9112, status is ok NOTICE : Module 2, Ports 12 is module type 1/2/4 Gbps FC Module and model DS-X9112, status is ok Port-Channel 7 is administratively up, Link is up, Line protocol is down. (host) mynode (config) show interface port-channel 7. *** Module Information & Status *** NOTICE : Module 1, Ports 16 is module type 1/2 Gbps FC Module and model DS-X9016, status is ok The examples below show the output of show interface port-channel 7 on a managed device.
![show interface errors show interface errors](https://img.yumpu.com/39442111/1/500x640/ipfast-error-messages-docsmindru.jpg)
Use the Support dropdown and choose Product and Diagnostics Tools / Environmental Analysis Tools / Switch Analysis Tool (SWAT) Have an example of the Interface Output. This will give a lot of info about your switch. You can also run the tech-support details and run it through the SWAT (Switch Analysis Tool). You can enter sh int and then hit tab and it will give you additional entries. Can't find any other commands other than the Show Interface commands.